Owner`s manual

GB 7
Cleaning the Connectors
The receiver may not operate properly if the connectors between the receiver and the detachable
face are contaminated with dirt. To clean the connectors, use a cotton swab and isopropyl alcohol
(90% or higher). Be sure to clean them with a vertical motion. Never clean them horizontally,
because this could damage the contact points.
Affixing the Detachable Face for Retail Display
The detachable face can be affixed to the receiver’s chassis, which is desirable for a retail display.
To affix the face, obtain the small self-tapping screw from the hardware pack and drive it into the
upper hole at the front left side of the chassis using a Phillips screwdriver. The bolt will self-thread
the hole. (See Fig. 8)
TROUBLESHOOTING – Refer to the receiver’s Owner’s Manual. If you have questions, please
consult your Blaupunkt dealer or in the United States call 1-800-266-2528.
Installer – These Installation Instructions are the property of the consumer!
Make sure they are left in the vehicle!
8 622 401 550
Fig. 8
Faceplate affixing screw goes here