Owner's Manual

Tuner mode
• Band: The Band menu allows selecting
the waveband or the memory bank.
You can switch between the menus with
the rocker switch < or > @.
Setting the waveband/memory
bank
You can adjust and set radio stations of the
FM and AM wavebands.
The FM and AM wavebands each feature 2
memory banks: FM and FMT as well as AM
and AMT. Each of the 4 memory banks fea-
tures 10 memory locations.
.... Press the> rocker switch @ twice to
open the "Band" menu.
.... Press the rocker switch /\ or v @ to
select the desired waveband or memo-
ry bank.
.... Press the OK button 0.
The desired waveband or memory bank is
adjusted. After a short period of time. the
display automatically returns to the "List"
menu.
You can now perform the following actions
in this waveband/memory bank:
• Tuning into a station
• Storing stations
20
Tuning into a station
There are 3 ways of tuning into a station:
• Tuning into stations automatically
(station seek tuning)
• Tuning into stations manually
• Selecting stored stations
Station seek tuning
.... Press the # button of the alphanumer-
ic keys@.
"SEEK" and the current frequency appear
on the display.
.... Press the rocker switch /\ or v @.
If you press and hold the rocker switch /\
or v @, automatic seek tuning skips the
stations found until you release the rocker
switch again.
Note:
You can also activate the "SEEK" func-
tion by using the> rocker switch @ to
open the "Tune" menu and pressing the
OK button 0.
The tuner searches for the next receivable
station in the current waveband. The ad-
justed sensitivity of the station seek tuning
(section "Changing the seek tuning sensitiv-
itt) is taken into consideration.
Tuning into stations manually
.... Press the # button of the alphanumer-
ickeys@.
"SEEK" and the current frequency appear
on the display.