Operating Instructions and Installation Instructions
41
Fitted units
Installation dimensions
Building in
min 35
Ventilation grid
min 35
Cupboard feet
460
50
Note: There should be gap above the oven.
• Do not hold or carry the appliance by the door handle. The door handle cannot hold the
weight of the appliance and may break off.
1. Carefully push the oven into the box, making sure that it is in the centre.
2. Open the door and fasten the oven with the screws that were supplied.
• This appliance is only intended to be fully tted in a kitchen .
• This appliance is not designed to be used as a tabletop appliance or inside a cupboard.
• The tted cabinet must not have a back wall behind the appliance.
• A gap of at least 35 mm must be maintain between the wall and the base or back panel of the
unit above.
• The tted cabinet must have a ventilation opening of 250 cm
2
on the front. To achieve this cut
back the base panel or t a ventilation grille.
• Ventilation slots and intakes must not be covered .
• The safe operation of this appliance can only be guaranteed if it has been installed in
accordance with these installation instructions.
• The tter is liable for any damage resulting from incorrect installation.
• The units into which the appliance is tted must be heat-resistant up to 90 °C.
min.
min.
Ventilation openings
behind, min. 250 cm
2
Ventilation area in the
base min. 250 cm
2
Ventilation in the
base min. 250 cm
2
Back
panels
open
Back
panel
open