Operation Manual

Table Of Contents
40
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
1. Insert the lower panel at an angle towards the back (fig. A).
2. Slide in the middle panel (fig. B).
3. Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
4. Hook the seal in to the bottom of the panel again (fig. D).
5. Insert the uppermost panel at an angle to the back into the
brackets. Take care not to push the seal to the back (fig. E).
6. Insert the two small seals on the left and right of the panel
again (fig. F).
7. Put the cover back in place and screw it on.
8. Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Error messages
When the indicator displays an error message with
, press
the
0 sensor. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
: Risk of electrical discharge and the resulting shock.!
Incorrect repairs can be dangerous. Repairs can only be
carried out by qualified personnel from the Technical
Assistance Service.
%$
'
&
)
(
Fault Possible
cause
Solution/advice
The oven does
not work.
The fuse has
blown.
Check the condition of the
fuse/circuit breaker in the
fuse box.
Power cut Check that the light in the
kitchen and other household
appliances are working.
The
0 symbol
lights in the dis-
play with some
zeros.
Power cut Set the time once again.
The oven does
not work.
There is dust in
the contacts.
Turn the control knob several
times in both directions.
The oven door
does not open.
The Hsymbol
lights up on the
display panel.
The oven door
has been
locked by the
self-cleaning
function
V.
Wait until the oven has
cooled and the
H symbol
turns off.
The display
shows
”‰.
The appliance
has been auto-
matically
turned off.
Turn the function control
knob to the zero setting.
Error message Possible cause Solution/advice
“‹‚‚
A sensor has
been pressed
for too long or
has got stuck.
Press all the sensors one
by one. Check if a sensor is
stuck, covered or dirty
“‚‹‡
The door lock
has been acti-
vated with the
door open.
Press the
0 sensor. You
can now begin program-
ming again.
“‚‚†
The tempera-
ture inside the
oven is too
high.
The door oven is locked
and heating has stopped.
Wait until the oven has
cooled. Press the
0 sensor
and reset the time.