Operation Manual

Table Of Contents
39
3. Reclose the attachment levers (picture C). Close the oven
door.
: Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
Removing the door covering
The oven door cover can change colour with time. For better
cleaning, we recommend removing the cover.
1. Fully open the oven door.
2. Unscrew the oven door cover. To do this, unscrew the right
and left hand side bolts (figure A).
3. Remove the cover (figure B).
Ensure that the oven door does not close when the cover is
not in place. The inside glass may damage.
Clean the surface using a product specifically for cleaning
stainless steel.
4. Refit and secure it.
5. Close the oven door.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the sequence
in which the panels are removed. In order to reassemble the
panels in the correct sequence, use the numbers that appear
on each panel.
Removal
1. Detach the oven door and lay it on a cloth with the handle
facing down.
2. Unscrew the cover at the top of the oven door. To do this,
unscrew the left and right screws (fig. A).
3. Lift the top panel up and pull it out and remove the two small
seals (fig. B).
4. Unscrew the retaining clips on the right and left. Lift the panel
and remove the clips from the panel (fig. C).
5. Remove the seal from the bottom of the panel (fig. D). Pull
the seal and remove it up and out. Pull out the panel.
6. Pull the lower panel at an angle, upwards and out.
7. Do NOT unscrew the left and right-hand screws from the
sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
: Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
&
%
$
%$
'
&
(