Operation Manual

38
Cleaning the self cleaning surfaces in the oven interior
The inside rear and side walls and ceiling of some ovens may
comprise a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning will be most effective at
higher temperatures and during longer cooking times.
Slight discolouration of the lining does not affect its self-
cleaning performance.
Caution!
■ Do not use abrasive cleaning products. These would scratch
and impair the highly porous lining.
■ Never use oven cleaning products on ceramics. If oven
cleaner is spilled on this accidentally, immediately remove it
using lots of water and a sponge.
Cleaning the oven's enamelled bottom and walls
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
Light
The oven light can be turned on manually to facilitate cleaning.
Connecting the oven bulb
Turn the function control knob to the
N position.
The light will come on.
Turning the oven light off
Turn the function control knob to the
Ûposition.
Removing and refitting the wire shelves or left
and right hand side rails
The wire shelves or left and right hand side rails can be
removed for cleaning. The oven must be cold.
Release the guides or rails
1. Lift the front of the guide or rail and release it (figure A).
2. Then pull the guide or rail forwards completely and remove it
(figure B).
Clean the guides or rails with detergents and a sponge. The
use of a brush is recommended for stubborn stains.
Install the wire shelves or rails
1. First insert the shelf or the rail in the rear groove by pushing it
back slightly (figure A)
2. then insert it in the front groove (figure B).
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.
Unhooking and hanging the oven door
The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
: Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Glass panels on
oven door
Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
Glass cover for the
oven light
Hot water and a little soap:
Clean with a dishcloth.
The seal
Do not remove!
Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Wire shelves or
rails
Hot water and a little soap:
Soak and clean using a dishcloth or brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do not
leave this to soak or wash in a dishwasher.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or brush.
Zone Cleaning products
%
$
%
$
%$