Operation Manual

Trouble shooting en
21
4. Push each panel in at the top (fig. #).
5. Put the cover back in place and press on it until you
hear it click into place (fig. $).
6. Open the appliance door again fully.
7. Close the two locking levers on the left and right
(fig. %).
8. Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3Trouble shooting
Tr oubl e s hoot i ng If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 23
--------
:Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault messages on the display panel
If a fault message (begins with "“") appears on the
display panel, e.g. “‹†‹ƒ, touch the p button. This will
reset the fault message. If necessary, reset the time on
the clock.
If the fault was a one-off, you can continue to use the
appliance as normal. If the fault message appears
again, notify our after-sales service. Quote the exact
fault message and the E no. (product number) of your
appliance. ~ "Customer service" on page 22
g


Fault Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
The time is flash-
ing on the display.
Power failure. Reset the time.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†‘”“.
The child-
proof lock is
activated.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.