User manual

41
1
2
3
4
5
6
EN
Buttonhole Stitching
4
3
2
-
-
-
1
4
2
3
4
2
Machine Setting
Stitch (1)
Stitch selector
Stitch length
Upper thread
tension dial 1 to 5
Buttonhole foot
Make a sample button hole using a piece
of the sample material as the garment.
Place the button on the fabric sample and
mark the top and bottom to determine the
buttonhole length.
Sew down the left side stopping
at the bottom mark. Raise the
needle.
Set the stitch selector at " ",
sew 5 stitches of bartack and
raise the needle up from the
fabric.
4
2
Set the stitch selector at " ".
Slide both threads to the left.
Lower the needle into the
garment where the buttonhole
is to start, and lower the foot.
1
Set the stitch selector at " ". Sew up the
right side of the buttonhole. Stop the machine
when yo
u are directly opposite the first stitch
on the left hand side and raise the needle.
3
Set the stitch selector at " ". Sew 5
bartacks stitches and raise the needle up
from the fabric.
Set the stitch length control to "0" and the
stitch selector at straight stitch sewing. Sew a
few locking stitches.
4
2
Remove the fabric from the machine and cut
the sewing threads. Insert a pin inside the
bartack. Then cut the opening with a seam
ripper. Take care not to cut the stitches.