User manual

EN
Machine Setting
Sti
Upper thread
tension dial
Use the darning plate for button sewing (see page 10).
A pin can be placed on top of the button to form a shank.
Set the stitch selector at "
the slot of the foot and place the left hole
of the button just below the needle point. Lower the foot and turn the
pattern selector until the needle point comes
just above the right hole of the button. Sew about five stitche
raise needle. Set the stitch selector at "
again and sew a few stitches to lock thread.
1
40
Sewing Buttons
3
2
1
Machine Setting
Sti
tch (9)
Stitch selector
Upper thread
tension dial
1 to 4
Stitch length control any number (not
necessary to adjust)
Darning plate
Zigzag foot
Use the darning plate for button sewing (see page 10).
A pin can be placed on top of the button to form a shank.
". Align both holes of the button with
the slot of the foot and place the left hole
of the button just below the needle point. Lower the foot and turn the
pattern selector until the needle point comes
just above the right hole of the button. Sew about five stitche
s and
raise needle. Set the stitch selector at "
"
again and sew a few stitches to lock thread.
To strengthen the shank, cut the
threads leaving a 20cm (8") trail.
Bring the needle thread down
through the hole
in the button and wind it around
the shank.
Draw the thread to the wrong
side and knot.
2
3
To strengthen the shank, cut the
threads leaving a 20cm (8") trail.
in the button and wind it around