User manual

EN
Adjusting Stretch Stitch Balance
Stitch Length Control
Setting mark
Stitch length
As long as you keep the reverse
stitch control depressed, the
machine sews backwards.
To Put on the Darning Plate:
1.
Position the darning plate
with
the 3 pins on the bottom.
2.
Fit the darning plate pins into
the needle plate holes. The
feed dogs will show through
the darning plate holes.
Darning Plate
Reverse Stitch Control
36
Adjusting Stretch Stitch Balance
Reverse Stitch Control
To select Stretch Stitches, set this control at SS position.
In stretch stitch sewing, Stitch Length Control should be in
the Center position between - and + (SS position) for most
materials. Depending upon the type of fabric used. You
may need to adjust this control to match
forward stitches of
stretch sewing with reverse motion stitches.
To shorten stretch stitches, turn the control slightly toward
"-" To lengthen, turn toward "+"
To Put on the Darning Plate:
Position the darning plate
the 3 pins on the bottom.
Fit the darning plate pins into
the needle plate holes. The
feed dogs will show through
the darning plate holes.
Use Left Needle Position for more
control while topstitching or edge
stitching difficult fabrics.
NOTE: Use only zigzag presser
foot for Left Needle Sewing
Left Needle Position
Stitch selector
Darning Plate
+ .SS. -
Smocking stretch
Rick rack stretch