User manual

Place bobbin into bobbin
case. Make sure the thread
unwinds in the direction of
arrow.
1
Always thread your machine with the power off!
33
1
Threading Bobbin Case
Threading the Machine
Place bobbin into bobbin
case. Make sure the thread
unwinds in the direction of
Pull the thread into the bobbin
case slot.
Draw the thread under the tension
spring and into the delivery eye.
* L
eave about 10cm (4 inches) of free
thread.
2
3
Raise the take-up lever to its highest position by turning
the
toward you. Raise the presser foot. Place the spool on th
e
with thread c
oming from the back of the spool.
1. Draw the thread into th
read guide using both hands.
2. Draw the
thread into the second (2) thread guide using both hands.
3. While holding the thread near the spool, draw th
e
tension area and then around the check spring holder
4. Firmly draw the thread up and through the take-
up lever from right to
left.
5. Draw the thread down and slip it into the
needle bar thread guide.
6. Thread the needle eye from front to back.
NOTE: You may want to cut the end of the
thread with a pair of sharp scissors
for easier ne
edle threading. Switch on the power after threading the machine and
bobbin. You are now ready to sew.
EN
Draw the thread under the tension
spring and into the delivery eye.
eave about 10cm (4 inches) of free
the
balance wheel
e
spool pin as shown,
read guide using both hands.
thread into the second (2) thread guide using both hands.
e
thread down into the
tension area and then around the check spring holder
.
up lever from right to
needle bar thread guide.
thread with a pair of sharp scissors
edle threading. Switch on the power after threading the machine and