User Manual

BlauHoff BLH-5KW Battery LFP Battery User Manual
40%-60% during storage. Disconnect the LFP battery from all loads
and, if present, the charging device. Store the battery in a cool and dry
place without direct sunshine. Keep the battery away from corrosive
substances, inflammable and explosive material as well as hazardous
gases. For long-term storage (＞6months), charge the LFP battery to
more than 80% of its rated capacity before storage. The battery needs
to be recharged every 6months to more than 80% of the rated capacity.
5 Installation and configuration
5.1 Installation preparation
5.1.1 Safety Requirements
Only those who have been trained in the power system and have a
good knowledge of the power system are allowed to install the device.
Always observe local safety regulations and the safety requirements
listed below during the installation process.
Before installing or removing the device, make sure that the power
system is not powered and that the battery device is turned off.
Distribution cabling should be reasonable and with protective
measures to avoid being touched during operation.
5.1.2 Checking the operating environment
The operating environment should meet the requirements
described in Chapter 3, “Operating Environment”. Otherwise, it needs
to be adjusted and re-examined.
5.1.3 Tools
The tools that may be used are shown in Table 5-1.
Table 5-1 Tools
Tools
Screwdriver (Slotted, Phillips)
Multimeter
Wrench
clip-on ammeter
Diagonal pliers
Insulating tape
Thermometer
Pliers
10