User Manual
Table Of Contents
- Safety requirements
- Purpose
- Delivery set
- Designation key
- Technical data
- DESIGN AND OPERATING PRINCIPLE
- Mounting and set-up
- Connection to power mains
- Control
- Technical maintenance
- Troubleshooting
- Storage and transportation regulations
- Manufacturer’s warranty
- Certificate of acceptance
- Seller information
- Installation certificate
- Warranty card
www.blaubergventilatoren.de
15
2. Fan inspection (once per year).
Take off the ventilation unit and clean the fan blades.
Remove dust using a soft brush, cloth or a vacuum cleaner.
Do not use water, abrasive detergents, solvents, sharp objects for
cleaning.
The impeller blades must be cleaned once a year.
To reset the operating hours counter after installing filters and a regenerator in the ventilator, press and hold
for 10 seconds. The red indicator, indicating that the filter is dirty, should go out.
3. Replacement of the remote control battery (if necessary).
Replace the battery of the remote control after prolonged use. No
response of the ventilator for pressing the remote control buttons
indicates the need to replace the battery.
The battery type is CR2025.
To replace the battery of the remote control, remove the battery
holder with a battery.
Replace the battery and install the holder with a new battery back
to the remote control.
+
CR2025
3V
+
CR2025
3V
Remove the ventilation unit. Clean the impeller blades.