User Manual
Table Of Contents
- Safety requirements
- Purpose
- Delivery set
- Designation key
- Technical data
- DESIGN AND OPERATING PRINCIPLE
- Mounting and set-up
- Connection to power mains
- Control
- Technical maintenance
- Troubleshooting
- Storage and transportation regulations
- Manufacturer’s warranty
- Certificate of acceptance
- Seller information
- Installation certificate
- Warranty card
www.blaubergventilatoren.de
11
Connection of several ventilators in series
When the ventilators are connected in series, all the connected ventilators are controlled with the first ventilator and a remote
control. To connect the ventilators in series, connect the control terminals with a cable as shown in the diagram below. Connect the
second ventilator with the third ventilator in the same way, etc.
For connection, use a screened cable with a wire cross-section of at least 0.25 mm (not included in the delivery set).
When the ventilators are connected in series, power must be supplied separately to each of them.
GND
In
Out
GND
LN
GND
In
Out
GND
LN
1~100-230 V
50/60 Hz
1~100-230 V
50/60 Hz
First ventilator Second ventilator
To the next
ventilator