Tus neeg siv phau ntawv
Table Of Contents
- Safety requirements
- Purpose
- DELIVERY SET
- DESIGNATION KEY
- Technical data
- DESIGN AND OPERATING PRINCIPLE
- MOUNTING AND SET-UP
- Connection to power mains
- Control
- Technical maintenance
- Troubleshooting
- Storage and transportation regulations
- Manufacturer’s warranty
- Certificate of acceptance
- Seller information
- Installation certificate
- Warranty card
CO
2
, VOC, HUMIDITY SENSOR MOUNTING NOT INCLUDED IN THE DELIVERY SET
The sensors are installed in the exhaust air duct upstream of the heat exchanger. Before installation, remove the protection plate and
remove the extract filter.
Install the CO
2
and VOC sensors in the respective brackets and connect the connectors to them.
1
2
5
4
6
3
1 – mounting bracket for the VOC sensor
2 – VOC sensor
3 – connector of the VOC sensor
4 – mounting bracket for the CO
2
sensor
5 – CO
2
sensor
6 – connector of the CO
2
sensor
To connect the humidity sensor, unscrew the screws securing the bracket and remove it.
Fix the humidity sensor with a screw on the bracket and connect the connector.
Install the bracket with the sensor to the unit.
CiViC eC lB(e/e2) 1200
12
www.blaubergventilatoren.de