User`s manual

OIL CLEANER INSERT

The oil cleaner replacement must be performed in accordance

with the Maintenance Plan (page 49), the best way to perform is

concurrently with engine oil change.

Drain the oil (page 55).

Unscrew the 3 bolts on the oil

cleaner cover and remove it.

Replace the oil lter.

Replace the engine block seal

with a new one.

Fit the cleaner cover with a

new O-ring and a install a new

oil lter.

Install the cover with new oil

lter into the crankcase and

tighten it using the 3 bolts. Be-

ware of proper position of the

oil lter, when assembling the

unit.

Bolts shall be tightened to the prescribed torque.

Tightening torque: 10 - 12 N.m (7.4 - 9 lbf.ft)

After lling the engine with recommended oil (page 21) check the

block for possible leakage.