User`s manual

ENGINE OIL

Check the level of engine oil (page 21).

Engine oil change:

The engine oil changes must be performed in accordance with

the Maintenance Plan (page 49). Let the engine warm up and

then wait for 2-3 minutes.

Install new O-ring on oil drain screw and screw it in.

Tightening torque: 20 - 23 N.m (14.8 - 18 lbf.ft)

Use the oil lling opening to add some oil in order to keep its level

approximately half way the gauge.

Recommended engine oil: Valvoline SAE 20W-50, API SG

Oil capacity: approx. 0.9 l (1.0 USqt, 0.8 lmp qt)

Insert the oil lling cap.

Check the oil level and the engine for possible leakages.

Install the frame and engine guard cover.

Unscrew the 4 bolts in the en-

gine bottom cover and remove

this cover.

Place the waste oil container

below the crankcase. Unscrew

the oil lling cap. Unscrew the

oil drain screw and let all the oil

drain out. Remove the strainer

from the oil drain opening, cle-

an it thoroughly and re-install

it into its initial position in the

crankcase.

Replace the oil lter (page 55).