Service manual

STARTING THE ENGINE

Engine starting should be done only on the stand - Fig. 2. Fill the fuel tank and

close it with the filler cap. Open the Gas petcock. Set the petrol supply cock.

Set the choke lever into position “C”, Fig. 3. Without turning the accelerating

handle, pull gently twice the starting wire and by next guick pull start the

engine. It is not allowed to pull the starting wire up to full winding off. The

choke lever will turn back to the position “A” automaticaly by turning the

accelerating lever after a short engine run . Let the engine run about 1 min.

Leave the minibike on the stand with running engine and if necessary adjust

the revolutions so the rear wheel is not turning. For adjustment use the

adjustment screw No. 3 on the carburetor Fig. 3.

Fig. 2

FIG. 3: CARBURETOR

1. Suction chamber

2. Carburetor body

3. Adjusting screw of no-load run

4. Float chamber

A – Cock position for riding

C – Cock position for cold starting

RIDING

Remove the minibike from the stand to sit on the seat. When seated, then

slowly rotate the throttle grip to start riding. Before braking, rotate the Throttle

grip to the off or idle position and lightly depress the rear brake lever with left

hand and then the front brake lever with right hand. Beware to not skid the

wheels. The minibike engine is switched off by pushing the red button (Engine

stop switch) on the handlebars. It is necessary to check the tightness of bolts

and nuts, especially of the engine, and the brake settings after the first ride and

often during the break in period.