User manual
PUTTING OUT OF OPERATION
STORAGE
REPEAT PUTTING INTO OPERATION
TECHNICAL SERVICE
PERMANENT PUTTING OUT OF OPERATION
During a longer putting out of operation it is recommended to drain all the fuel from
the tank and the carburetor. Fill up the tires to operational pressure and place the
minibike on to the stand.
Furthermore, during a longer putting out of operation, unscrew the spark plug and
drip several drops of engine oil into the cylinder. Then pull the starting cord several
times, to form an oil lm over the entire cylinder.
Do not leave the machine exposed to climate effects and if you intend to store it for a
long period of time then ensure the preserving of all parts, which may be susceptible
to oxidation. The storage must take place in a dry environment, where the tempera-
ture moves in the range of 0° to 50°C. Storage temperature -10°C to 60 °C (-10°F to
140°F), relative humidity: 20 to 80% non-condensing.
Before beginning the preparation of the machine for operation, carefully perform the
degreasing and un-preserving of all areas and parts which are protected against co-
rrosion, using a suitable degreasing product designated for degreasing, which does
not cause a danger of an explosion, disturbance of painted surfaces and so on.
Contact your dealer in the case of any unclarity with this manual or with the mainte-
nance and service of your minibike. The updated list of the dealers is stated on the
Internet pages of the manufacturer www.BLATA.com.
In the case of disassembling the machine please refer to the manufacturer which will
secure the disassembly in accordance with the valid safety regulations.
Do not drain the uids used in the machine into the environment. First remove all
the uids used in the machine. Remove plastic and rubber materials, such as seals,
hoses, cable covers, etc. These materials should be liquidated in accordance with the
relevant regulations for liquidation of plastics.
Remove the engine, electrical devices and cables and hand over the copper parts for
further use. It is necessary to deliver the disassembled components to the relevant
centers for recycling and liquidation of waste. The machine does not contain any ma-
terials which would require special manipulation or processing during the liquidation
of the machine.
25 26