User manual

the groove in the plate
lies on the groove in the neck
g. 14
g. 15
upper plate - bearing in the front (in the rear)
lower plate - bearing in the rear (in the front)
spacer tube
The change is possible using the adjustable supports of the rear fork, which enable to
change the height of the seat in the range of approx. 3.5 cm.
Change of the seat height
adjustable supports of the rear fork
main bolt of the rear fork
g. 16
The adjustment is performed by the replacement of the spacer rollers of various leng-
ths on the disassembled supports of the rear fork. We follow the following procedure
during the replacement. Remove both the supports of the rear fork from the minibike.
Totally unscrew the securing bolts from the supports. Replace the spacer rollers with
others (just by sliding on). Always use the same length rollers (marked by groups) on
both of the supports. Place the assembled support with the seating areas of the end
pieces on to a at pad, screw in and tighten the securing bolt. Loosen the main bolts
on both sides in the front part of the rear fork. Mount the supports onto the minibike
and tighten the main bolts on the rear fork.
It is possible to achieve sixteen various positions of the foot rests, using the combi-
nation of 4 holes in the foot rest holders, the rotary cam and two holes in the front end
piece of the rear fork. The suitable angle of the foot rest can be adjusted by turning the
foot rest in the spline, through which it is attached to the foot rest holder.
important warning regarding the change of the geometry of the chassis:
With regards to the fact that the change of the geometry of the chassis results in the
change of the spatial arrangement of a signicant amount of parts, always check, fol-
lowing the performing of the change of the geometry of the chassis, whether any collisi-
on is occurring between the parts (radiator X front wheel , cowling X brake lever, intake
lter X rear wheel, cowling X front wheel, steering shock absorber X radiator etc.)
Change of the foot rests position
seating areas of the end pieces – parallel!
at pad
spline
foot rest holder
rotary cam
2 holes in the front end
piece rear fork
4 holes in the
foot rest holders
foot rest
spacer roller of various lengths
securing bolt
g. 17
g. 18
proper setting of the steering plate
in the steering neck
example of the correct positioning of
the steering plates against each other
17 18