SDS

11/182020
EN (English)
Page 4
SECTION 6: ACCIDENTAL RELEASE MEASURES
6.1 Personal precautions, protective equipment and emergency procedures
Fully encapsulating, vapor protective clothing should be worn for spills and leaks with no fire. Do not
touch and walk through spill area. Do not touch damaged container or spilled material unless wearing
appropriate protective clothing/equipment. Ventilate the closed area.
6.2 Emergency procedures
Isolate the spill / leak area in all directions for about 50 meters (150 ft) for liquids and about 25 meters
(75 ft.) for solids and semi-solids. Eliminate all ignition sources (no smoking, flares, sparks / flames in
close vicinity). Keep unauthorize person away and ventilate closed space before entering.
6.3 Environmental procedures:
Use appropriate measures for containment of spilled material to the environment. Prevent from
entering/ spreading to drain, water, river, ditches by using sand, earth, floor dryers or other appropriate
barriers.
6.4 Methods and materials for containment and cleaning up
Shovel into suitable properly marked container for disposal or reclamation in accordance with local
regulations.
6.5 Reference to other sections
Refer to section 8 – exposure control / personal protection and section 13- disposal considerations
SECTION 7: HANDLING AND STORAGE
7.1 General Precautions
Store in well-ventilated area, if risk on vapor inhalation is there. Use the information in this data sheet
as input for risk management arising due to local conditions which help to manage safe handling of this
product.
7.2 Precautions for safe handling
Avoid prolonged and repeated contact with skin. Avoid inhaling the vapors/mist. When handling the
drums, kegs, pails etc., proper safety shoes, and other protective clothes, safety glasses etc. should be
worn. Dispose appropriately any contaminated rags/material as per prevailing local allowable practices.
Keep containers in closely tight and, cool and well ventilated areas.
7.3 Conditions for safe storage, including any incompatibilities
Keep containers tightly close, well-ventilated areas but covered, avoiding contact with rain or other
water ingress possibilities. Keep the storage place cool preferably <120
°
F / <50
°
C. Higher temperature
may create pressure buildup inside container and chances of container busting or leakage may occur
under aggravated conditions. Keep away from other oxidizing and incompatible materials.
Incompatible Products : Strong oxidizing agents . Strong reducing agents
SECTION 8: EXPOSURE CONTROLS / PERSONAL PROTECTION