Specification

EXPOSURE CONTROLS/PERSONAL PROTECTION
8
Eye wash stations and emegrency showers should be immediately available.
Engineering Controls:
Eyes and Face: Standard safety glasses with splash shields typically offer adequate
protection. Where excessive splashing or spraying is possible, a face shield should be
used.
Skin and clothing: Excessive contact should be avoided. Neoprene gloves, boots and
aprons will provide adequate protection when contact cannot be avoided. Remove and
wash any contaminated clothing immediately. Wash thoroughly after handling.
Respiratory: Good general ventilation should be sufficient to control airborne levels.
Maintain airborne concentrations below OSHA established exposure limits of
ingredients in Section 2.
Protective Equipment:
The Blaster Chemical Companies takes no responsibility for determining what
measures are required for personal protection in any specific application. This
information should be used with discretion.
Exposure Guidelines/Other:
PHYSICAL AND CHEMICAL PROPERTIES
9
Clear viscous oilyAppearance:
LiquidPhysical State:
slightOdor:
8.8pH:
Not determinedVapor Pressure:
3.8 (air = 1)Vapor Density:
360 FBoiling Point:
Not determinedFreezing/Melting Pt.:
nilSolubility:
0.97 (water = 1)Spec Grav./Density:
Not determined
7.27 lbs/gal
>1 (NBA = 1)
Not determined
Not applicable
Not determined
Not applicable
Not applicable
Not determined
90
Not determined
Not determined
Heat Value:
VOC:
Evap. Rate:
Bulk Density:
Octanol:
Molecular Weight:
Particle Size:
Softening Point:
Viscosity:
Percent Volatile:
Sat. Vap. Concentrat.:
Molecular Formula:
Silicone Lube
Material Safety Data Sheet
Revision Date: 08/25/08MSDS Number: SL - Bulk
Page of
3 5
MSDS
The Blaster Corporation