MSDS

eyes.
Eye Contact:
Ingestion may cause irritation to the mouth, esophagus and stomach.Ingestion:
Aerosols:
Sudden release of pressure could produce projectiles and atomized combustible liquid.
Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and
nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
FIRST AID MEASURES
4
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Continue to monitor. Get medical attention.
Inhalation:
Remove contaminated clothing immediately! Wash skin with soap and water. If irritation develops,
seek medical attention.
Skin Contact:
Flush eye(s) with water for 15 minutes. Get medical attention. If eye irritation persists, obtain
medical treatment.
Eye Contact:
Do not induce vomiting! Get medical attention immediately!Ingestion:
FIRE FIGHTING MEASURES
5
Flash point: 150
o
F (TCC) minimum
Extinguishing Media: Dry chemical, carbon dioxide or foam is recommended. Water may be ineffective for extinguishment,
but can be useful in minimizing or dispersing vapors, protecting personnel and cooling containers. If containers are not
properly cooled they can rupture in the heat of a fire. Avoid spreading burning liquid with water used for cooling purposes.
Unusual Fire & Expolsion Hazards: Level 3 Aerosols - Contents Under Pressure!
ACCIDENTAL RELEASE MEASURES
6
Eliminate all sources of ignition and ventilate the area. See section 8 for the appropriate personal protection. Aerosol cans
should be handled with caution. Sudden release of pressure could produce projectiles and atomized combustible liquid.
Leaking aerosol cans should be put into suitable container until the internal pressure has dissipated. Take precautions to
prevent contamination of ground and surface waters. Do not flush into sewers or storm drains. Use suitable absorbents to
collect liquid product. Consult regulations for the proper disposal of the container, liquid and absorbents.
HANDLING AND STORAGE
7
Use in accordance with good industrial workplace practices. Avoid unnecessary contact.
Wash thoroughly after handling. Use with good ventilation.
Handling Precautions:
Store in a dry place away from excessive heat. Store containers with lids on and properly
labeled.
Do not store at temperatures above 120 degrees F.
Storage Requirements:
PB Penetrating Catalyst
Material Safety Data Sheet
Revision Date: 10/15/10MSDS Number: PB - Aerosol
Page of
2 6
MSDS
The Blaster Corporation