Specification
Silicone
Lube
Safety Data Sheet
according
to
the
Hazard
Communication
Standard
(CFR29
1910.1200)
HazCom
2012.
06/11/2015
EN
(English)
5/5
12.2. Persistence and degradability
Silicone Spray Lubricant
Persistence and degradability Not established.
12.3. Bioaccumulative potential
Silicone Spray Lubricant
Bioaccumulative potential
Not established.
12.4. Mobility in soil
No additional information available
12.5. Other adverse effects
No additional information available
SECTION 13: Disposal considerations
13.1. Waste treatment methods
Waste disposal recommendations : This material must be disposed of in accordance with all local, state, provincial, and federal
regulations. The generation of waste should be avoided or minimized wherever possible.
Additional information
:
Flammable vapours may accumulate in the container.
SECTION 14: Transport information
In accordance with DOT
14.1. UN number
UN-No.(DOT) : UN1950
14.2. UN proper shipping name
DOT Proper Shipping Name : AEROSOLS, flammable, limited quantities
Hazard class (DOT) 2.1
Packing Group (DOT) Not applicable.
Hazard labels (DOT) :
14.3. Additional information
Other information : No supplementary information available.
Special transport precautions : Do not handle until all safety precautions have been read and understood.
SECTION 15: Regulatory information
15.1. US Federal regulations
Petroleum distillates, hydrotreated light (64742-47-8)
Listed on the United States TSCA (Toxic Substances Control Act) inventory
Alkanes, C9-11-iso- (68551-16-6)
Listed on the United States TSCA (Toxic Substances Control Act) inventory
15.2. US State regulations
Silicone Spray Lubricant()
State or local regulations
This product does not contain a chemical known to the State of California to cause
cancer, birth defects or other reproductive harm.
SECTION 16: Other information
Indication of changes : None.
Other information
:
None.
This information is based on our current knowledge and is intended to describe the product for the purposes of health, safety and environmental requirements only. It should not therefore be
construed as guaranteeing any specific property of the product