MSDS

Physical Hazard: Aerosol containers are pressurized (even when empty!) Do not expose to temperatures above 120
0
F. Do
not puncture or burn can. Failure to observe these precautions may result in rapid and violent decompression of the container
producing projectiles and atomization of the liquid contents.
Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and
nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
FIRST AID MEASURES
4
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Continue to monitor. Get medical attention.
Inhalation:
Remove contaminated clothing immediately! Wash skin with soap and water. If irritation develops,
seek medical attention.
Skin Contact:
Flush eye(s) with water for 15 minutes. Get medical attention. If eye irritation persists, obtain
medical treatment.
Eye Contact:
Do not induce vomiting.! Get medical attention immediately!Ingestion:
FIRE FIGHTING MEASURES
5
Flashpoint: lowest component 52
O
F (TCC) - Actual Flashpoint of complete product is estimated to be higher.
Unusual Fire & Explosion Hazard: Although this aerosol product is classified as nonflammable under ASTM D 3065-77
Flame Projection Test, this product should not be used or stored near any open flames or ignition sources. Contents under
pressure. Self-pressurized aerosol containers. Keep temperature of containers below 120 deg. F. to prevent bursting.
Extinguishing Media:
Water fog, dry chemical, carbon dioxide
Special Fire Fighting Procedures: Water may be used to cool closed containers to prevent pressure build-up and possible
bursting when exposed to high temperatures. Firemen should wear self-contained, positive pressure, respiratory equipment.
ACCIDENTAL RELEASE MEASURES
6
Spill or Leak Procedure: Leaking aerosol cans should be put into suitable container until the internal pressure has
dissipated.
Waster Disposal Method:
Dispose of in accordance with local, state and federal regulations.
HANDLING AND STORAGE
7
Use in accordance with good industrial workplace practices. Avoid unnecessary contact.
Wash thoroughly after handling. Use with good ventilation.
Handling Precautions:
Store in a dry place away from excessive heat. Store containers with lids on and properly
labeled.
Do not store at temperatures above 120 degrees F.
Storage Requirements:
Ice Blaster
Material Safety Data Sheet
Revision Date: 01/09/12MSDS Number: IB aerosol
Page of
2 7
MSDS
The Blaster Corporation