MSDS

ACCIDENTAL RELEASE MEASURES
6
Leaking aerosol cans should be put into suitable container until the internal pressure has dissipated. Use suitable absorbents
to collect liquid product. Consult regulations for the disposal of the container, liquid and absorbents.
HANDLING AND STORAGE
7
Use in accordance with good industrial workplace practices. Avoid unnecessary contact.
Wash thoroughly after handling. Use with good ventilation.
Handling Precautions:
Store in a dry place away from excessive heat. Store containers with lids on and properly
labeled.
Do not store at temperatures above 120 degrees F.
Storage Requirements:
EXPOSURE CONTROLS/PERSONAL PROTECTION
8
Eye wash stations and emergency showers should be immediately available.
Engineering Controls:
Eyes and Face: Standard safety glasses with splash shields typically offer adequate
protection. Where excessive splashing or spraying is possible, a face shield should be
used.
Skin and clothing: Excessive contact should be avoided. Nitrile gloves, boots and
aprons will provide adequate protection when contact cannot be avoided. Remove and
wash any contaminated clothing immediately. Wash thoroughly after handling.
Respiratory: Good general ventilation should be sufficient to control airborne levels.
Maintain airborne concentrations below OSHA established exposure limits of
ingredients in Section 2.
Protective Equipment:
The Blaster Chemical Companies takes no responsibility for determining what
measures are required for personal protection in any specific application. This
information should be used with discretion.
Exposure Guidelines/Other:
CSP - Corrosion Stop
Material Safety Data Sheet
Revision Date: 03/25/09MSDS Number: CSP - aerosol
Page of
3 7
MSDS
The Blaster Corporation