Instructions / Assembly

Setup
This product must be set up and supervised by an adult. Use
only on grass or soft surfaces. Do not install inflatable devices
over concrete, asphalt, packed earth, carpet or any other hard
surface. A fall onto a hard surface can result in serious injury
to the user. Always make sure the ground is debris-free before
setup, and never drag across rough surfaces.
Your Blast Zone® inflatable is designed to be used ONLY on
level surfaces. Keep a distance of no less than 1.8m (6ft) in any
direction from any structure or obstruction such as fence, garage,
house, overhanging branches, laundry lines, or electrical wires.
Unroll product on a suitable, dry, soft and debris-free surface. Do
not allow any players into the inflatable before it is fully inflated
and anchored.
Connect blower(s) to the long inlet, and tie securely. (If your
inflatable has an outlet tube, tie this shut before inflating). Use
only the blower supplied with your inflatable, or a manufacturer
specified replacement blower to avoid damage and potential injury.
Anchor the blower to the ground using the stakes provided. Do
not use the blower near water or in wet conditions (position the
blower so it is away from any over spray, puddles, wet players,
etc). If the blower becomes wet, discontinue use until it is dry.
A GFCI device needs to be used (if your blower is not already
equipped with one). Do not use an extension cord to power
the blower. Keep the blower and power cord away from water.
Plug in and start the blower; your unit will inflate within a couple
minutes. You must leave the blower running the entire time
the inflatable is being used. You will hear air “breathing” out
of seams and fabric. This is intentional to allow air to escape.
Once fully inflated, anchor the inflatable product to the ground
using the stakes provided - your inflatable includes at least 2
anchoring stakes per side, for use in normal soil conditions. For
loose soil, or areas that may require additional anchoring, larger
stakes may be required (sold in local hardware stores) or optional
sand bag achors (sold separately) may be added. Stakes must be
installed flush with the ground to avoid tripping hazards. Never
use the inflatable without anchoring it to the ground.
If your inflatable requires water attachments, attach the hoses
in the correct configuration to the inflatable.
a. Attach a standard garden hose to the inlet of the sprayer
assembly.
b. Slowly open the valve on your garden hose, allowing only
enough water for proper use of the item. Limiting water
saves natural resources, and protects the sprayer assembly
from damage caused by too much pressure.