User Manual

5
2. Disassembly of the Rifle
4
CAUTION!
Unload your rifle before disassembly
(refer to page 8).
Removing forearm
• Support the rifle at the buttstock on your
thigh.
• Pull forearm flap out with a finger of one
hand, and disengage forearm from the
barrel by pressing with the fingers of your
other hand.
• Tilt forearm away from barrel at a slight
angle and pull it up, out of the hinge
Unhinging barrel set
(only possible when forearm is removed)
• Press locking lever all the way to the right
and hold it in this position.
• Tilt barrel all the way down. Doing so,
the barrel hook is disengaged.
2.2.
Removing breech block
(with barrel unhinged)
This is only necessary, when you want to
thoroughly clean the rifle or safeguard it
against unauthorised use by removing the
breech block.
• Press block lock 11 beside the trigger
and keep it pressed down.
• Now press the locking lever simultaneously
to the right, until breech block disengages.
• When disengaging, the block snaps
forward a little and can now be removed,
accessing it from the front.
Reinstalling breech block
• Put breech block with the semicircular
shaft bearing 14 onto the shaft in the
bottom of the receiver and tilt it backwards
into its tilted position.
• Press block lock 11 beside the trigger
and keep it pressed down. Now, the l
ocking lever can be pushed all the way
to the right (a bit further than for opening
the rifle).
• Hold locking lever in this position, you
may reengage the breech block 11 now.
• Now press the breech block at its rear end
down into the receiver and release the
locking lever.
NOTE:
If you tilted the breech block all the way to
the back into its locked vertical position
during installation, push the locking lever
(without pressing block lock 11 ) to the
right again and allow the block to snap back
into its position of a slight forward inclination,
by pushing it slightly forward. In this position,
the rifle can be fired.
2.4.
2.3.
2.1.
1. Assembly of the Rifle
Securing barrel set
(only possible when forearm is removed)
• Seat the front barrel hook onto the hinge
bolt. Due to the tight fit, this requires care.
• Grip around barrel hook part and action
with one hand, press barrel hook into its
seat, thus closing the rifle.
• Do not operate locking lever during this
process.
CAUTION:
The breech block must be in its correct
position (slightly inclined forwards). Should
the block be in a vertical position, the barrel
cannot be closed. In this case, press the
locking lever all the way to the right and,
with your other hand, return the breech
block into its forward inclined position.
NOTE:
Securing the barrel requires a certain
amount of skill. Do not use force!
We suggest having this procedure
demonstrated by an expert and practise
several times in his presence.
CAUTION:
Under no circumstances must barrel sets
of S 2 Safari models be installed in regular
S 2 actions. Due to different trigger pulls,
doubling cannot be excluded when shooting
with Safari calibres. Danger of injury!
Installing forearm
• Engage forearm on hinge bolt, flush with
the receiver, and tilt it onto the barrel,
until it reaches the stop.
• The best manner to do this is to lift the
forearm flap with your index finger and
hold it in this position.
• Press in forearm.
• The forearm flap engages.
• Close the forearm flap completely.
The forearm is now locked.
1.1.
1.2.