Manual

9
8. Open sights
8
5. Loading the Rifle 6. Firing 7. Unloading
Loading
• Remove oil from barrels and chamber and
check them for foreign matter.
• Convince yourself under all circumstances
that the ammunition corresponds with the
calibre of your rifle.
• Insert the appropriate cartridges into the
chambers.
• Close the rifle.
Firing
• Cock the rifle by pushing the safety slide
(cocking slide) forward.
• Sight at target and fire:
- the front trigger releases the shot
in the right barrel
- the rear trigger releases the shot
in the left barrel.
CAUTION:
When only one shot is fired, one hammer
remains cocked! MORTAL DANGER!
When you do not intend to fire the second
shot immediately, lock (uncock) the rifle
before putting it down!
Please remember that, after firing the first
shot, there is still a live cartridge in the
barrel which was not fired!
NOTE:
After firing one or two shots, the safety sli-
de (cocking slide) remains in its forward po-
sition. When the locking lever is pushed to
the right before breaking the rifle, the safety
slide (cocking slide) jumps back into the po-
sition "safe (uncocked)” automatically.
CAUTION:
The Blaser S 2 (S 2 Safari) is equipped with
direct pull triggers.
The setting of the trigger pull can and may
only be changed at the factory.
NOTE:
Please check trigger regularly for smooth
movement, with the rifle unloaded and
locked (uncocked).
Gummy oil and/or contaminations may
affect proper functioning of the trigger
and cause malfunctions.
Unloading the rifle
Open the rifle.
When breaking the barrel, the cartridges are
pulled out by the extractor far enough to be
taken out fully by hand.
7.1.
Considering differing sighting habits and re-
quirements, the rifle is zeroed-in over open
sights at the factory with approximate preci-
sion only. Precise zeroing-in by adjusting fo-
resight and rear sight should be performed
by yourself, together with your specialised
dealer, in order to adjust the sights precisely
to your personal requirements.
Foresight with elevation adjustment
Insert Allen key SW 0.9 into the bore in the
foresight from above, and turn Allen screw
as needed. The foresight works with spring
support.
When shooting deep:
Turn Allen screw to the right.
When shooting high:
Turn Allen screw to the left.
Rear sight (sight) with lateral
adjustment
The base of the sight contains a locking
screw.
When shooting to the left: loosen locking
screw, slide sight to the right side and tighten
locking screw.
When shooting to the right: loosen
locking screw, slide sight to the left side
and tighten locking screw.
NOTE:
In the model S 2 Safari, foresight and
rear sight are not adjustable. Corrections
can only be performed at the factory or
by an authorised dealer.
8.2.
8.1.
5.1.
6.1.