Instruction Manual

44
1. Close the action (push the bolt handle all
the way to the front) and uncock the rie
2. Hold the rie horizontally and in an up-
right position
3. Pull out the illumination dial (illuminated
turns on)
4. dial 2x darker, 1x brighter, 3x darker
within 6 seconds (turn the rotary rocker
switch to the respective stop briey and
allow it to spring back).
5. As soon as the reticle illumination ashes
quickly, move the cocking slide into the
cocked position
6. Actuate the illumination dial 1x darker
(reticle illumination ashes slowly).
7. The ashing stops after 3 seconds. The
illuminated dot lights up at the previously
set brightness level. The pairing process
is now complete.
8. Uncock the rie.
The reticle illumination is now switched on
and o automatically by cocking or uncock-
ing the rie when the illumination is switched
o (illumination dial pushed in).
Deleting the iC coupling
To delete the coupling of the iC cocking
slide with the riescope, repeat the pairing
process, however at step 6 turn 1x brighter.
Possible errors
If the illumination ashes quickly for a further
6 seconds after step 6, the pairing process
was not successful and needs to be repeat-
ed. If the pairing process fails again, the
combination of riescope,rie and mountig
position is not optimal and the detected dif-
ference between the cocking slide positions
was too small.
iC mode
Cocking a Blaser rie equipped with iC auto-
matically activates the reticle illumination of
the Blaser riescopes. The hunter is imme-
diately ready to shoot. As a result they gain
time, a sense of calm and therefore safety.
A sensor in the ocular of the riescope de-
tects the position of the cocking slide and
switches the reticle illumination on or o
automatically. This reliably ensures that the
illuminated dot is always activated when the
rie is cocked before shooting. Operation
of the rie and scope is reduced to a single
movement. The hunter only has to adjust
the light intensity to the prevailing light con-
ditions at the start of the hunt.
The iC mode is active when the illumination
dial is pushed in.