Instruction Manual

43
English
43
Auto-o functions
Blaser riescopes are equipped with move-
ment and tilt sensors to extend the battery
life. These sensors detect the position and
movements of the rearm and switch the
illumination o or on automatically. The il-
lumination switches o automatically under
the following conditions:
f tilted 70° upwards
f tilted 80° downwards
f tilted 60° to either side
f after 10 minutes without movement
As soon as the weapon is placed in a rele-
vant angle position again, or is moved, the
illumination switches on automatically again.
If the iC function is used, the lighting can be
switched on in all angle positions by cocking
the rearm. The switching o function after
10 minutes without movement remains
active.
Battery warning function
If the battery voltage is low, the illumination
ashes for 3 seconds when switched on and
then continues to be constantly lit. In this
case, replace the battery with a new one at
the next possible opportunity.
Setting the illuminated reticle and the
iC control
All Blaser riescopes are equipped with
the iC function. In interaction with a rie
equipped with an iC cocking slide, this ena-
bles automatic activation of the illumination
when cocking the rie. When decocking the
rie, there is a delay of a few seconds beore
the illumination switches o, to prevent it
from switching o when the action is cycled
during reloading.
Pairing process
To use the riescope in iC mode, it is nec-
essary for the riescope to be programmed
for (paired with) the individual rearm. The
position of the rearm may not be changed
during these steps. Perform these steps as
follows:
IMPORTANT:
Always ensure that the firearm is unloaded
before starting this process!