Owner's Manual
8
4. Assembling, taking down
WARNING:
G Make sure there are no cartridges in
the chamber or magazine.
4.1 Assembling
• Remove the 4 mm T-allen key from its
pocket in the shipping carton. With the
barrel screw studs pointing down, insert
the barrel into the receiver (fig. 1).
fig. 1
fig. 2
fig. 3
• Then, insert the T-allen key into the
holes on the bottom of the fore-end
and tighten the two allen screws
equally locking the barrel and receiver
together (fig. 2).
NOTE:
Do not use any extension tools on the
allen key to tighten screws. Good hand
tightness is sufficient.
• Insert the magazine from the bottom
into the receiver until both magazine
releases are engaged (fig. 3).