Owner's Manual
24
16. Stock
16.3 Cheekpiece:
• After loosening cheekpiece knob the
cheekpiece can be moved up or down.
To remove the cheekpiece from the
stock just pull it out of the top.
• To maintain the same elevation of the
cheekpiece when removing and instal-
ling adjust the cheekpiece stop to the
desired position.
• Loosen allen screw M5x30 with 3 mm
allen key. To adjust the on-/offset of the
cheekpiece add or remove spacers on
the inside.
16.4 Handrest:
• With the 4 mm T-allen key supplied,
loosen the 2 allen screws and remove
handrest.
• Add or remove spacers to set the
desired height.
• Installation in reverse.
The following adjustments are possible:
- Buttplate elevation
- Length of pull
- Cheekpiece height and on-/offset
- Handrest
16.1 Buttplate
• Loosen baseplate knob and move butt-
plate to desired elevation and tighten.
16.2 Length of pull
• With the 4 mm T-allen key supplied,
loosen allen screw and remove butt-
plate
• Loosen and remove allen screws which
hold the spacers to the baseplate.
Add or remove spacers to set the
desired length of pull.
• Installation in reverse.
NOTE:
• When installing 1 or 2 buttplate
spacers use allen screws M5x25.
• When installing 3 or 4 buttplate
spacers use allen screws M5x50.