Instruction Manual

37
11.2.
Removing the scope
• Hold the rifle with your left hand at the forearm
and support it on your thigh.
• Open both lids of the holding elements.
• First swivel the rear holding element with your
thumb all the way to the front/up until it reaches
the stop.
• Grip scope with your right hand at the center
tube and hold it.
• Now swivel the holding element at the front with
your thumb all the way to the front/ up until it
reaches the stop.
• Remove scope, moving it to the right side and up.
CAUTION:
If the distance between eye and scope (eye relief)
is too short and if the rifle is not seated correctly at
your shoulder, injuries are not to be excluded when
shooting with big calibers. Especially in case of big
calibers, care has to be taken that the distance
between eye and scope (eye relief) is appropriate
and that the rifle is seated correctly at the shoulder.
12. Mounting the Scope
US-Type
12.1.
Installing the scope
• Turn both lateral Allen screws SW 1/8" at the
mount CCW several turns.
•
Hold scope with your right hand at the centre
tube above the mount.
• Hold ri
fle at the forearm with your left hand,
support buttstock on your thigh.
•
Insert the two round studs at the scope mount
car
efully into the two oval holes sunk into the
upper right side of the barrel, tilt scope to the
left onto the barrel and hold scope in this position
with your left hand.
• Tighten both lateral Allen screws at themount
finger
-
tight with Allen key SW 1/8".
12.2.
Removing the scope
• Grip around forearm and scope with your left
hand and support rifle on your thigh.
• Loosen both lateral Allen screws at the mount
with Allen key SW 1/8" several turns.
• Remove scope.
english