Instruction Manual

43
Locking screw DamperNotch
Balancerweight
Adjusting the weight distribution
• Remove the forearm.
• Remove the barrel set.
• Loosen the threaded rod in the top
chamber of the USGL barrel by using a
5 mm Allen Key and remove it.
• Loosen the locking screw of the balancer
weights with a 2 mm Allen Key.
• Screw the balancer weights into the desi-
red position.
• Tighten the locking screw of the balancer
weights with a 2 mm Allen Key.
• Insert the threaded rod in the top
chamber of the USGL barrel, screw it in
with a 5 mm Allen Key and tighten it.
NOTE:
To avoid damaging the threaded rod, please
ensure when tightening the locking screws
N that you are screwing them down onto
the flat side of the rod and not directly onto
the thread.
NOTE:
The balancer is as a rule, fitted with one
balancer weight.
Depending on the stock weight, barrel
weight and/or personal preference the
balancer can be set without weight, with
one weight or up to five weights.When
using one or more weights, the fine adjust-
ments of balance are made through turning
the weights in the needed direction until
the desired balance is achieved.
NOTE:
Barrel balancers are not compatible with
stock balancers.
english