Instruction Manual

38
5.14. F3 Barrel Balancer
Included
1
2 large weights
(63.8 g / 2¼ oz. each)
2
4 small weights
(42.5 g / 1½ oz. each)
3
8 mounting screws (M3)
4
Torx-wrench No. 10
DANGER: A loaded weapon is a
danger to life! Secure and unload
the gun before removing the
forearm. Please follow the general
safety rules of the F3 operating
instructions.
5.13.5. Returning stock balancer
• Ensure that the muzzle is pointing down
and resting on a non-slip surface.
• Tighten the balancer with the 5 mm Allen
Key.
NOTE:
When returning the ba lancer, ensure that
both the stock and spring washer are cor-
rectly in place on the stock connecting rod,
inside the stock. Through tightening the
balancer the stock will be secured. Please
ensure that the balancer is firmly tightened.
5.13.6. Returning the non-adjustable re-
coil pad
• Insert the point of the screws L and M
located in the recoil pad, back into the
pre-drilled hole in the back of the stock.
• Tighten the screws using the size 1 phillips
screwdriver.
NOTE:
When tightening screws L and M, ensure
that the recoil pad lines up flush with the
stock.
5.13.7. Returning the adjustable recoil
pad*
• Return the recoil pad with recoil pad fixing
plate and adjustment plate.
• Slide the recoil pad with recoil pad fixing
plate and adjustable plate down to the
bottom.
• Tighten screw H with the 1.5 mm Allen
Key (approx. 5 turns).
NOTE:
The settings of the recoil pad will not be
altered through this removal or return.