Instruction Manual

9.1.
9.2.
26
9. Mounting of Scope
Installing scope
Removing scopeThe Blaser D 99 has been prepared for
installation of the Original Blaser saddle
mount (DBP). We assume that your
scope has been mounted correctly on
the appropriate barrel by your specialized
dealer.
• Open lid of rear and front mount lever
and ensure that both are swivelled all the
way to the front /up.
• Hold rifle at the forearm with your left
hand, support buttstock on your thigh.
• Hold scope with your right hand at the
centre tube, above the mount, so that
you can reach the front lever with your
thumb.
• Insert the two round studs at the scope
mount carefully into the two oval holes
sunk into the upper right side of the
barrel, tilt scope to the left onto the
barrel and hold it in this position.
• Press the (opened) mount levers, first
the one in front and then the one in
the back, backwards/downwards with
your thumb, until they reach their stop
position (tension!). If this is too easy
or requires a lot of force, the mount is
maladjusted. Have your dealer correct
this according to works instructions.
• Now close the two lids of the mount
levers.
Please ensure that the engaging surfaces
are clean and free from grease.
• Hold the rifle with your left hand at the
forearm and support it on your thigh.
• Open both lids of the mount levers.
• First swivel the rear lever with your
thumb all the way to the front/up - until
it reaches the stop.
• Grip scope with your right hand at the
centre tube and hold it.
• Now swivel the mount lever at the front
with your thumb all the way to the front/
up - until it reaches the stop.
• Tilt scope to the right and remove it.
CAUTION:
If the distance between eye and scope
is too short and if the rifle is not seated
correctly at your shoulder, injuries are not
to be excluded when shooting with large
calibres.