Instruction Manual

7.1.
8.1.
8.2.
25
english
7. Unloading the Rifle
8. Open Sights
Unloading the Rifle
Foresight with elevation
adjustment
Rear sight (sight) with lateral
adjustment
• Open the rifle.
• When breaking the barrels, the
cartridges are pulled out by the extractor
far enough to be taken out fully by hand.
Considering differing sighting habits and
requirements, the rifle is zeroed-in over
open sights at the factory with approximate
precision only. Precise zeroing-in by
adjusting foresight and rear sight should
be performed by yourself, together with
your specialised dealer, in order to adjust
the sights precisely to your personal
requirements.
• Insert Allen key SW 0.9 into the bore in
the foresight from above, and turn Allen
screw as needed. The foresight works
with spring support.
When shooting deep: Turn Allen screw
to the right.
When shooting high: Turn Allen screw to
the left.
The rear sight is designed as a folding sight,
offering two notches of different sizes.
• Rear sight folded to the front: Fine rear
sight notch for precise shooting.
• Rear sight folded back: Coarse rear sight
notch for driven hunt situations.
• At the side of the base of the sight, two
locking screws are provided.
When shooting to the left: Loosen left
screw, tighten right screw.
When shooting to the right: Loosen right
screw, tighten left screw.