Instruction Manual

5.1.
6.1.
24
5. Loading the Rifle
6. Firing
Loading the Rifle
Firing
• Remove oil from barrels and chambers
and check them for foreign matter.
• Convince yourself under all
circumstances that the ammunition
corresponds with the calibres of your
rifle.
• Insert the appropriate cartridges into the
chambers.
• Close the rifle.
• Cock the rifle by pushing the safety slide
(cocking slide) forward.
• Sight at target and fire:
Firing lower barrels: Push change-over
lever down (Fig. 1 + 2). The trigger in
front releases the shot in the right barrel,
the one in the back releases the shot in
the left barrel.
• Firing the upper barrel and the lower
left barrel:
Push change-over lever upward
(Fig. 3 + 4 – red dot in change-over lever
becomes visible!). The trigger in front
releases the shot in the upper barrel. The
trigger in the back releases the shot in
the lower left barrel.
CAUTION:
When only one shot is fired, one hammer
remains cocked! MORTAL DANGER!
When you do not intend to fire the second
shot immediately, lock (decock) the rifle
before putting it down! Please remember
that, after firing the first shot, there are still
live cartridges in the barrels which were not
fired!
NOTE:
After firing one or two shots, the safety
slide (cocking slide) remains in its forward
position. When the locking lever is pushed
to the right before breaking the rifle,
the safety slide (cocking slide) jumps
back into the position "safe (decocked)”
automatically.
CAUTION:
Blaser Drillings are equipped with direct
pull triggers. The setting of the trigger
pulls can and may only be changed at the
factory.