Instruction Manual

19
english
General Safety Rules
Only use ammunition which meets the
CIP requirements, in particular with
regards to the maximum gas pressures
P
max
according to CIP regulations. Every
Blaser rifle is controlled and tested by
the state proof-house according to the
requirements of the proofing-law and
-regulations, using proof cartridges
exceeding the maximal allowed gas
pressure P
max
by a minimum of 30%.
If gas pressures exceed proof-level, the
safety of the user and/or third parties
can no longer be guaranteed. The same
applies to cartridge cases, where the seal
function is no longer correct through
obturation.
Load your firearm only immediately
before use.
Disengage from safe position (cock)
your firearm only immediately before
shooting. Hold barrel into a direction out
of danger during disengaging (cocking).
Check the surrounding area, before
every shot.
Point your firearm only at a target, which
you have clearly identified.
Only put your finger on the trigger, when
you want to shoot.
Only fire a shot, when a secure back stop
exists.
When a cartridge fails, wait approx.
60 seconds before opening the action, to
avoid danger through hang-fire.
Wear hearing protection during
shooting.
Unload your firearm
before crossing obstacles,
before climbing and leaving raised hides,
before entering a building,
before climbing into a vehicle,
before entering a built area,
and also, when you lay down or hand on
the firearm temporarily.