Instruction Manual

44
1. Assembly
of the Rifle
1.1.
Securing barrel set
(Only possible with forearm removed)
• Pull out extractor all the way to the stop.
• Seat the front barrel hook onto the hinge
bolt. Due to the tight fit, this requires
care.
• Grip around barrel hook part and action
with one hand, press barrel hook into its
seat, thus closing the rifle.
NOTE:
Securing the barrel set requires a certain
amount of skill. Do not use force!
We suggest having this procedure demons-
trated by an expert and practise several
times in his presence.
1.2.
Installing forearm
• Engage forearm on hinge bolt, flush
with the receiver, and tilt it onto the
barrel, until it reaches the stop.
• The best manner to do this is to lift the
forearm flap with your index finger and
hold it in this position.
• Press in forearm.
• The forearm flap engages.
• Close the forearm flap completely.
The forearm is now locked.
2. Disassembly
of the Rifle
CAUTION:
Unload your rifle before disassembly
(refer to page 7).
2.1.
Removing forearm
• Support the rifle at the buttstock on your
thigh.
• Pull forearm flap out with a finger of one
hand, and disengage forearm from the
barrel by pressing with the fingers of your
other hand.
• Tilt forearm away from barrel at a slight
angle and pull it up, out of the hinge.
2.2.
Unhinging barrel set
(Only possible with forearm removed)
• Press locking lever all the way to the
right and hold it in this position.
• Hold and tilt barrel all the way down.
Doing so, the barrel hook is disengaged.