User Manual

3
USE
1 - Burner 1 – button
2 - Burner 1 + button
3 - Burner 5 – button
4 - Burner 5 + button
5 - Burner 2 – button
6 - Burner 2 + button
7 - Burner 4 – button
8 - Burner 4 + button
9 - Burner 3 – button
10 - Burner 3 + button
11 - Clock button
12 - Clock programming – button
13 - Clock programming + button
14 - Safety lock button
15 - ON/OFF button
16 - Burner in use position indicator
17 - Timer display
18 - Burner heat settings display (0 - 7)
FUNCTIONS available to the user/fitter:
the main functions of the device are:
● standby mode (burners off, control panel active).
● Control panel lock to protect against accidental lighting/programming.
● Regulation of the capacity of every burner at 7 levels.
● Safety lock with manual reset via release procedure carried out from the control panel.
● Procedure to regulate the capacity to the minimum level for every burner (for fitter only).
● Programming the type of fuel used: methane/lpg (for fitter only).
● Programming of the switch off time for every burner.
● Maximum duration time for each burner pre-programmed into the FLASH memory equates to 4
hours.
● Temperature measured on the electronic card.
● Management of anomalies/faults via code indicated on display.