User Manual

INSTALLATION

4) FIXING THE COOKTOP

The hot plate has a special seal which prevents

liquid from infiltrating into the cabinet. Strictly

comply with the following instructions in order to

correctly apply this seal:

- detach the seals from their backing, checking that

the transparent protection still adheres to the seal

itself.

- Overturn the hot plate and correctly position seal

“E” (fig. 8) under the edge of the hot plate itself, so

that the outer side of the seal perfectly matches

the outer perimetral edge of the hot plate. The

ends of the strips must fit together without

overlapping.

- Evenly and securely fix the seal to the hot plate,

pressing into place with the fingers and remove the

strip of protective paper from the seal and set the

plate into the hole made in the cabinet.

- Fix the hob with the proper brackets “S” and fit the

prominent part into the porthole “H” on the bottom;

turn the screw “F” until the bracket “S” stick on the

top (fig. 9).

- When the appliance is installed so that the base

can be touched, we recommend fitting a

protecting shield. This shield must be at least

60 mm below the base of the bench top (fig. 7).

Timber or other suitable material may be used

provided it is capable of withstanding the

appliance temperatures. Ensure that the supply

connection point is accessible with the appliance

installed. To facilitate the shield may need to be

removable.

NOTE: do not fix the cooktop into the bench

with sealant (ie silicon) as this may void the

warranty. Use only the seals provided.

FIG. 8 FIG. 9