User manual

21
Fitting the vapour protection
Screw the vapour protecting strip onto the front part of
the worktop using four 3,5 x 16 screws.
Fixing to the adjacent units
The appliance must be secured to the underside of
the worktop using the brackets provided.
Failure to do this could cause damage or injury.
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher as shown in the
figure.
Secure the brackets to the adjacent units with the
3.5 x 16 screws using the upper or the side holes.
Attention!
The sides of the dishwasher must never be
drilled to prevent damage to hydraulic
components.
600 mm
600 mm
II25
II54