User manual

7
Safety thermostat
Should the main oven thermostat fail, the
oven is protected by a safety thermostat
which will operate if the temperature within
the oven reaches too high a level.
Once the temperature has returned to a
safe level the main oven thermostat will
function.
In cases where there is a permanent failure
it is necessary to contact the nearest
Service Centre.
When the appliance is first
installed
Once the oven is installed it is important to
remove the protective materials which were
put on in the factory.
Remove the plastic film from these parts,
then wipe with a cloth dipped in hot soapy
water.
Then switch the controls of the both ovens
to and the thermostat controls to MAX;
then, leave them to run empty for 30
minutes to burn off any other protective
materials.
This will also remove any unpleasant
smells.
The BDO 770 consists of two ovens. The
upper or main oven is evenly heated. A fan
in the back wall distributes heated air round
the food during cooking so that everything
cooks in the same time regardless of where
it is placed in the oven or how full the oven
is. Foods of different types, provided they
require the same cooking temperature, can
be cooked together and there is no
possibility of any flavours or smells being
transmitted from one food to another.
The lower oven is a traditional one and
contains a grill.
Cooling fan
The cooling fan is designed to cool the walls
of the oven and the components of the oven
itself.
The fan switches on automatically after a
few minutes of cooking.
Warm air is blown out through the aperture
near the oven door handle.
When the oven is switched off, the fan will
remain on in order to cool the oven and
kitchen cabinets properly, after which it
switches off automatically.
NOTE: The fan may run up to 45 minutes
after cooking has been completed. Leaving
the door ajar will lessen the cooling time.