Installation and Operation Guide

9
MAINTENANCE AND CLEANING
Switch-off
the cooktop before cleaning.
Do not clean the cooktop if the glass is too hot because they are risk
of bur
n.
• Remove light marks with a damp cloth with washing up liquid diluted in a little water. Then
rinse with cold water
and dry the surface thoroughly.
• Highly corrosive or abrasive detergents and cleaning equipment likely to cause scratches
must be absolutely avoided.
• Do not ever use any steam-cleaner or pressure washer.
• Do not use any object that may scratch the ceramic glass.
• Ensure that the cooktop is dry and clean. Ensure that there are no grains of dust on your
ceramic cooktop or on the pan. Sliding rough saucepans will scratch the surface.
• Spillages o
f sugar, jam, jelly, etc. must be removed immediately. You will thus prevent the
surface being damaged.
TROUBLESHOOTING
The cooktop or the cooking zone doesn’t start-up:
• The cooktop is badly connected to the electrical
system.
• The protection fuse has blown.
• The locking function is activated
• The sensitive keys are covered by grease or water.
• An object is covering the control panel.
The symbol [ E ] displays :
• Call the After-sales Service.
One or all cooking zones cut-off:
• The safety system has engaged
• You forgot to cut-off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and has overheated.
The automatic cooking system « go and stop » doesn’t start-up:
• The cooking zone is still hot [ H ]
• The highest power level is set [ 9 ]
• The cooking level was engaged with [ - ]
The symbol [ L ] displays :
• Refer to the chapter control panel locking page.
The control panel displays [ Er03 ] :
• An object or liquid covers the control keys. The symbol disappears as soon as the key is
released or cleaned.
The control panel displays [ ER21 ] :
• The cooktop is overheated, let it cool and then turnit on
again.
The control panel displays [ U400 ], [ Er25 ]or [ U4 ] :
• The cooktop is not connected to the network. Check the connection and reconnect
the cooktop.
If one of the symbols above persists, contact the Service Centre.