Owner manual

avbmdl1sm-rev0111 Model AVB Metallic Page 9
 



 
Startup/Settle/Deadhead Solid
Standby/Low Flow 1 Second ON / 1 Second OFF
Learn Mode 0.1 Seconds ON / 0.1 Seconds OFF
Seek/Optimize 1 Second ON / 0.1 Seconds OFF
Steady State/Air Savings OFF / ON in rhythm with Cycle Rate of Pump


• Make sure power switch on the control module is turned on, (depressed to the left)
• Make sure air is being supplied to pump or make sure 110 VAC unit has power
being supplied to it

• Cycle power switch off/on
• Unplug patch cable and cycle power switch off/on
• Consult Factory After Sales Support team


• Make sure patch cable is plugged in and locked

• Consult Factory After Sales Support team


• Consult Factory After Sales Support team




• Consult Factory After Sales Support team


• Check for varying environmental pumping conditions (changing head or suction)
• Check ice buildup in exhaust area
• Inspect sleeve and spool set for damage

• Consult Factory After Sales Support team


• Run pump without AirVantage and check pump operation
• Make sure pump has correct sleeve and spool set installed
• Make sure patch cable plug is connected and locked
• Make sure power wire connectors are tight

• Consult Factory After Sales Support team


• Run pump without AirVantage and check operation
• Cycle the power off/on to the control module to reset controller
• Check ice buildup in exhaust area
• Inspect sleeve and spool set for damage

• Consult Factory After Sales Support team
• Cycle the power switch on the control module off/on