Owner`s manual

STEP 3

Please remove the M8xP1.25x20L Screws (H-3) and Flat Washers (H-2) on the rear Stabilizer

(G). en t and attach the rear Stabilizer (G) with slide rail (H-12) with the M8xP1.25x20L

Screws (H-3) and Flat Washers (H-2).

Remarks: Do not screw one set of the M8xP1.25x20L Screws and Flat Washers too tightly at

one time. It is better to x the four sets rmly at the same time to allow you to change angles

and to level easily.

STEP 4

1. Please remove the M5x35L Screws (H-11) on the Slide Rail (H-12)

2. Pass the Slide Rail (H-12) through the Slide Seat (H-4)

3. Use the M5x35L Screws (H-11) to x the Stopper (I-5) on the Slide Rail (H-12).