BLH02400 Blade Vusion V2 250 FPV RTF Manual

12
EN
WARNING: Remove the propellers from the motors prior to performing any maintenance or changing any radio
components. Failure to do so may cause serious injury if the motors start unexpectedly.
Model Type
ACRO
F-Mode Setup
Switch 1 B
Switch 2 H
Channel Assign
Channel Input Confi g
1 Throttle Throttle
2 Aileron Aileron
3 Elevator Elevator
4 Rudder Rudder
5 Gear B
6 Aux 1 H
Frame Rate
22ms
DSMX
Servo Setup
Channel Travel Reverse
Throttle 150/150 Normal
Aileron 150/150 Reverse
Elevator 150/150 Normal
Rudder 150/150 Reverse
Gear 100/100 Normal
Aux1 100/100 Normal
D/R & Expo
Channel Sw Pos D/R Expo
Aileron
0 100/100 20%
1 100/100 20%
2 100/100 20%
Elevator
0 100/100 20%
1 100/100 20%
2 100/100 20%
Rudder
0 100/100 20%
1 100/100 20%
2 100/100 20%
Timer
Mode Count Down
Time 6:00
Start Throttle Out
Over 25%
One Time Inhibit
SETUP LIST FUNCTION LIST
Spektrum Transmitter Setup
Adding An External Spektrum
™
Receiver
The Blade
®
Vusion
™
quadcopter is compatible with the
Spektrum
™
DSMX
®
quad race serial receiver (SPM4648).
After connecting the receiver, you must change the active
receiver on the fl ight controller using Betafl ight Confi gurator
software, available at
https://github.com/betafl ight .
To install a remote receiver:
1. Remove the top rear cover by pressing down on the rear
edge and pulling the cover out of the frame.
2. Disconnect the stock receiver from the fl ight control board.
3. Connect the Spektrum DSMX receiver connector to the
fl ight control board as shown.
4. Secure the receiver in the frame.
5. Re-install the rear cover.
6. Load Betafl ight Confi gurator.
7. Connect the quadcopter to the computer using the micro
USB port.
8. Select “Receiver” from the Confi gurator menu.
9. Under “Channel Map” select “TAER 1234”.
10. Select “Confi guration” from the Confi gurator menu.
11. Under “Serial Receiver Provider” select receiver
“SPEKTRUM2048” .
Switch Functions:
Switch B: Flight Mode
Pos 0: Angle Mode
Pos 1: Horizon Mode
Pos 2: Acro Mode
Switch H: Motor Arm/Disarm
Pos 0: Disarmed
Pos 1: Armed
To arm the motors, lower the throttle fully and move switch
H to position 1.
Stock
receiver
connector
Spektrum
receiver
connector