User Manual


3)SetuptheVideoLink
Toavoidthetraditional‘dip-switchchaos’atraceevents,theVortexdoesnotuseaDIPswitch
todefineVideoTxchannels.Instead,theOSDisresponsibleforsettingthechannel,andband.
TheVortexshipswithadefaultTxfrequencyof5740MHz,whichcorrespondsto
ImmersionRC/FatSharkfrequencies,Channel1.
IfyouarerunningImmersionRCreceivers,oraFatSharkheadsetusingthestandard5.8GHz
module,justselectChannel1,andthewizardimageshouldbeshown.
Ifyouarerunningnon-ImmersionRC/FatSharkgearwhichcannottuneto5740MHz,itmaybe
necessarytoswitchbandsontheVortexbeforethewizardimageisdisplayed.Todothis,set
yourreceivertoChannel1,andusethebuttonontheLEDboard(rearofthequad).

Toswitchbands,pressthebuttonontheLEDboardforapprox.2secondsuntilyouhearthe
firstbeep,andrelease..
TheVortexwillbeepanumberoftimes,representingthebandnumber.Eachtimethebuttonis
pressed,thebandnumberwillbeincremented.
Theband/beeporderisasfollows:
Band1:IRC/FS(5740MHz)
Band2:RaceBand(5658MHz)
Band3:BandE(5705MHz)
Band4:BandB(5733MHz)
Band5:BandA(5865MHz)
Forafulllistofchannelfrequenciesforeachband,pleaserefertothefullInstructionManual. 



9

